Technical Service Bulletins
|Publication Date: December 3, 2010|
Some 2009-2010 F-150 vehicles may exhibit excessive effort with the gear selector lever in cold climate conditions. This may be caused by snow building up around the shift cable and lever. A new snow shield kit has been released to alleviate this condition.
Follow the Service Procedure to correct the concern.
Install a snow shield. Refer to the kit instructions for proper installation.
|PART NUMBER||PART NAME|
|AL3Z-7B147-A||Snow Shield (4X4)|
|AL3Z-7B147-B||Snow Shield (4X2)|
Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
|102407A||2009-2010 F-150: Install Snow Shield (Do Not Use With Any Other Labor Operations)||0.4 Hr.|
|BASIC PART NO.||CONDITION CODE|
NOTE: The information in Technical Service Bulletins is intended for use by trained, professional technicians with the knowledge, tools, and equipment to do the job properly and safely. It informs these technicians of conditions that may occur on some vehicles, or provides information that could assist in proper vehicle service. The procedures should not be performed by “do-it-yourselfers”. Do not assume that a condition described affects your car or truck. Contact a Ford, Lincoln, or Mercury dealership to determine whether the Bulletin applies to your vehicle. Warranty Policy and Extended Service Plan documentation determine Warranty and/or Extended Service Plan coverage unless stated otherwise in the TSB article. The information in this Technical Service Bulletin (TSB) was current at the time of printing. Ford Motor Company reserves the right to supercede this information with updates. The most recent information is available through Ford Motor Company's on-line technical resources.
Copyright © 2010 Ford Motor Company