Technical Service Bulletins
|Publication Date: AUGUST 13, 2001|
|1997 EXPEDITION, F-150, F-250 LD|
This article is being republished in its entirety to update the labor time.
Water may be present in the transfer case on some vehicles. This may cause:
- Transfer Case Mode Switch to become inoperative
- The 4X4 “Low Range” light to appear dimly lit
- The intermittent wipers to become erratic or inoperative
- Vehicle Speed Sensor (VSS) Diagnostic Trouble Codes (DTCs) P0500, P0503, P1500, and P1501 to be set.
This may be caused by water splashing into the transfer case through the vent tube assembly, possibly causing the transfer case mode switch to short out, and/or the VSS gear to swell and set the VSS DTCs listed above. Shorting out the transfer case mode switch may cause the intermittent wiper mode to function erratically, as well as possibly causing the 4X4 light to work incorrectly.
Inspect, diagnose, and/or replace the necessary components. Refer to the following Service Procedure for details.
Procedure for VSS Gear:
- Inspect VSS gear in the transfer case for looseness.
- Replace Gear (C8OZ-17285-B) as necessary. Refer to Section 308-07B of the 1997 F-150/250 Workshop Manual for removal and installation procedures.
Procedure for Transfer Case Mode Switch:
- Check resistance of the Transfer Case Mode Switch.
- The resistance of the switch should be at least 100,000 ohms. If it is less, replace the switch (3-Position Switch, E7TZ-7E440-A, manual shift only). Refer to Section 308-07B of the 1997 F-150/250 Workshop Manual for removal and installation procedures.
Procedure for Transfer Case Vent Replacement:
- Remove old vent hose from fitting on front of transfer case.
- Attach end of new Vent Hose (F75Z-7A246-AA) to fitting, and route the hose up over the top of the transfer case (Figure 1).
- Attach the clip on the vent hose to the top of the vertical rib on the transfer case extension housing to support the end of the hose (Figure 2).
NOTE: FOR ALL WATER CONCERNS, DRAIN AND REFILL THE TRANSFER CASE WITH FRESH FLUID (XT-2-QDX), AND REPLACE THE VENT HOSE WITH THE REVISED PART.
|PART NUMBER||PART NAME|
|F75Z-7A246-AA||Transfer Case Vent Hose|
|C8OZ-17285-B||Vehicle Speed Sensor (VSS) Gear|
|XT-2-QDX||Motorcraft MERCONÂ® Multi-Purpose Automatic Transmission Fluid (ATF)|
OTHER APPLICABLE ARTICLES:
Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage
|011606A||Drain And Refill Transfer Case, Inspect And/Or Replace VSS Gear And Transfer Case Mode Switch, And Install Vent Kit||1.2 Hrs.|
|BASIC PART NO.||CONDITION CODE|
202000, 206000, 508000, 508300, 698298
Figure 1 – Article 01-16-6
Figure 2 – Article 01-16-6
Copyright Â© 2001 Ford Motor Company