Fulltext TSBs

Technical Service Bulletins

TSB
06-25-5
  • 4.2L HIGH IDLE – INITIAL START UP
Publication Date: December 1, 2006

FORD:
2007 F-150

ISSUE:

Some 2007 F-150 vehicles equipped with a 4.2L engine may experience a higher than expected idle on initial startup.

ACTION:

Reprogram the powertrain control module (PCM) to the latest calibration using IDS release 45.6 and higher or 46.1 and higher. This new calibration is not included in the VCM 2006.11 DVD. Calibration files may also be obtained at www.motorcraft.com.

WARRANTY STATUS:

Eligible Under Provisions Of New Vehicle Limited Warranty Coverage

OPERATIONDESCRIPTIONTIME
062505A2007 F-150 4.2L Check For Diagnostic Trouble Codes and Reprogram The Powertrain Control Module (Do Not Use With 12650D)0.4 Hr.

DEALER CODING

BASIC PART NO.CONDITION CODE
recal04

NOTE: The information in Technical Service Bulletins is intended for use by trained, professional technicians with the knowledge, tools, and equipment to do the job properly and safely. It informs these technicians of conditions that may occur on some vehicles, or provides information that could assist in proper vehicle service. The procedures should not be performed by “do-it-yourselfers”. Do not assume that a condition described affects your car or truck. Contact a Ford, Lincoln, or Mercury dealership to determine whether the Bulletin applies to your vehicle. Warranty Policy and Extended Service Plan documentation determine Warranty and/or Extended Service Plan coverage unless stated otherwise in the TSB article. The information in this Technical Service Bulletin (TSB) was current at the time of printing. Ford Motor Company reserves the right to supercede this information with updates. The most recent information is available through Ford Motor Company’s on-line technical resources.

Copyright 2006 Ford Motor Company