Fulltext TSBs

Technical Service Bulletins

TSB
95-18-4
  • AIR CONDITIONING – FORD APPROVED FLUSHING PROCEDURES – SERVICE TIP
Publication Date: SEPTEMBER 11, 1995

FORD:
1985-1986 LTD
1985-1988 EXP
1985-1994 TEMPO
1985-1995 CROWN VICTORIA, ESCORT, MUSTANG, THUNDERBIRD
1986-1996 TAURUS
1989-1993 FESTIVA
1989-1995 PROBE
1994-1995 ASPIRE
1995-1996 CONTOUR
LINCOLN-MERCURY:
1984-1992 MARK VII
1985-1986 MARQUIS
1985-1987 LYNX
1985-1994 TOPAZ
1985-1995 COUGAR, GRAND MARQUIS, TOWN CAR
1985-1996 CONTINENTAL
1986-1996 SABLE
1987-1989 TRACER
1991-1993 CAPRI
1991-1995 TRACER
1993-1995 MARK VIII
1995-1996 MYSTIQUE
MERKUR:
1985-1989 XR4TI
1988-1989 SCORPIO
LIGHT TRUCK:
1985-1990 BRONCO II
1985-1995 BRONCO, ECONOLINE, F-150-350 SERIES
1985-1996 RANGER
1986-1995 AEROSTAR
1991-1996 EXPLORER
1993-1995 VILLAGER
1995-1996 WINDSTAR

This TSB is being republished in its entirety to include Labor Operations for system flushing.

ISSUE:

Ford Motor Company has approved a procedure to provide technicians with a non-CFC method of flushing contaminated A/C system heat exchangers (evaporators and condensers). This procedure allows the A/C components to be cleaned and flushed while installed in the vehicle. The types of contamination flushed include particle matter which results from compressor or desiccant failure and the gummy residue which may form when refrigerant oil is overheated. Some Ford authorized HFC-134a retrofit kit procedures will also require A/C system flushing to remove mineral oil for capacity reasons.

ACTION:

Refer to the following text for proper flushing procedures.

The flushing procedure is a two-step process which involves the use of an A/C Flusher. The Flusher is used to do the following:

  1. Circulate the flushing solvent through the A/C system heat exchangers in the reverse direction of normal refrigerant flow (back flushing). Particle matter is filtered from the returning solvent and the solvent is returned to the reservoir for continued circulation.
  2. Remove the flushing solvent from the A/C system. In this step, pressurized air (90-125 psi/620-862 kPa) is used to push and evaporate any remaining flush solvent from the heat exchangers.

    Only Rotunda Item No. 014-00990 A/C Flushing Kit which includes 014-00991 A/C Flusher, 014-00992 A/C Flusher Fitting Kit, and F4AZ-19579-A A/C Flushing Solvent (case of 4 gallons/15 L), is approved for use on Ford vehicles. No other flushing device or solvent is approved by Ford Motor Company for flushing A/C systems. The use of other equipment or solvent may cause damage to the A/C system and the flushing unit.

    Minimum time for flushing is 15 minutes and minimum time for air flushing is 30 minutes. Failure to continue air purge for the entire 30 minutes as specified may result in residual amounts of flush solvent contaminating the A/C system. Residual flush solvent in a functioning A/C system may lead to A/C system failure.

    Do not flush through orifice tubes, TXVs, accumulator/driers, receiver/driers, mufflers or hoses. Internal plumbing and material make-up of these components make it impossible to properly remove the debris and/or residual flushing solvent.

    One (1) gallon (3.8 L) of Ford A/C System Flushing Solvent is used in this device and is intended for one (1) vehicle only. It may be used to flush both heat exchangers on an individual vehicle, but under no circumstances should it be used on more than one (1) vehicle. The filter used when flushing is also intended for use on one (1) vehicle only.

    NOTE:DURING THE FLUSHING PROCESS, THIS MATERIAL MAY COLLECT RESIDUE FROM THE A/C SYSTEM, WHICH MAY INCLUDE CFC-12. DISPOSE OF THE SOLVENT AND FILTER IN ACCORDANCE WITH FEDERAL, STATE AND LOCAL REGULATIONS.

    Use of A/C system filter kits as prescribed in TSB 94-15-5 is optional if the A/C system is flushed. Filter kit use is recommended after flushing if the system is highly contaminated. If the hoses are clogged with debris, hose replacement is required.

    Always remember to match oil properly, replace the accumulator/drier and orifice tube, or TXV and receiver/drier when servicing an A/C system with a compressor or desiccant failure.

    The following vehicles require A/C system flushing with retrofit kits to remove mineral oil for capacity reasons.

    • 1993 Probe 2.0L and 2.5L
    • 1988-90 Escort 1.9L EFI
    • 1989-93 Thunderbird Super Coupe
    • 1986-92 Mark VII
    • 1991-93 Capri 1.6L and 1.6T
    • 1988-93 Festiva 1.3L
    • 1987-90 Tracer 1.6L
    • 1985-89 XR4Ti
    • 1988-89 Scorpio

OTHER APPLICABLE ARTICLES:

94-15-5

SUPERSEDES:

95-8-1

WARRANTY STATUS:

Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage For 1991-95 Lincolns And All Other 1992-95 Models

OPERATIONDESCRIPTIONTIME
951804AFlush Evaporator1.0 Hr.
951804BFlush Condenser1.0 Hr.

DEALER CODING

BASIC PART NO.CONDITION CODE
1970349

OASIS CODES:

208000, 208200, 208999


Copyright © 1995 Ford Motor Company