Technical Service Bulletins
|Publication Date: March 7, 2005|
Some 2004 F-150 vehicles equipped with a 5.4L 3V or 4.6L engine may exhibit a rough idle condition.
Retrieve any diagnostic trouble codes (DTCs) if present, follow appropriate pinpoint test(s) as directed by the PC/ED manual. After repair, or if there were no DTCs present, reprogram the powertrain control module (PCM) to the latest calibration using WDS release B36.2 or higher. Calibration files may also be obtained at www.motorcraft.com.
Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
|050515A||2004 F-150 Check For Diagnostic Trouble Codes And Reprogram The Powertrain Control Module Only (Do Not Use With 12650D, 12650D84)||0.4 Hr.|
|BASIC PART NO.||CONDITION CODE|
NOTE: The information in Technical Service Bulletins is intended for use by trained, professional technicians with the knowledge, tools, and equipment to do the job properly and safely. It informs these technicians of conditions that may occur on some vehicles, or provides information that could assist in proper vehicle service. The procedures should not be performed by “do-it-yourselfers”. Do not assume that a condition described affects your car or truck. Contact a Ford, Lincoln, or Mercury dealership to determine whether the Bulletin applies to your vehicle. Warranty Policy and Extended Service Plan documentation determine Warranty and/or Extended Service Plan coverage unless stated otherwise in the TSB article. The information in this Technical Service Bulletin (TSB) was current at the time of printing. Ford Motor Company reserves the right to supercede this information with updates. The most recent information is available through Ford Motor Company’s on-line technical resources.
Copyright © 2005 Ford Motor Company