Technical Service Bulletins
|Publication Date: September 1, 2004|
Some 2004 F-150 vehicles may exhibit hood movement at the back of the hood due to high air turbulence, while driving at highway speeds. This condition may be amplified by the installation of an accessory bug shield and may be more pronounced when passing an on-coming vehicle on a two lane road.
Refer to the following Service Procedure.
- Confirm that the hood is flush with the front fenders at each front corner. If the hood is under-flush, adjust the hood stops to raise the hood flush with the tops of the front fenders.
- Check the amount of drag at the rear hood to cowl seal with a piece of paper. Place a piece of paper between the seal and hood, close the hood and then slowly pull the paper out.
- If there is sufficient drag, indicating good seal to hood contact, return the vehicle to the customer.
- If there is little to no drag, obtain locally a piece of fuel hose 147 cm long & 11 mm diameter (58″ long & 3/16″ diameter). Lube the hose with a soap-based solution and install the hose inside the hood seal bulb.
Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
|041808A||Check And Adjust Hood, Includes Time To Adjust Hood Bumper Stops, Check Hood Rear Seal And Install Hose Inside Hood Seal Bulb||0.4 Hr.|
|BASIC PART NO.||CONDITION CODE|
NOTE: The information in Technical Service Bulletins is intended for use by trained, professional technicians with the knowledge, tools, and equipment to do the job properly and safely. It informs these technicians of conditions that may occur on some vehicles, or provides information that could assist in proper vehicle service. The procedures should not be performed by “do-it-yourselfers”. Do not assume that a condition described affects your car or truck. Contact a Ford, Lincoln, or Mercury dealership to determine whether the Bulletin applies to your vehicle. Warranty Policy and Extended Service Plan documentation determine Warranty and/or Extended Service Plan coverage unless stated otherwise in the TSB article. The information in this Technical Service Bulletin (TSB) was current at the time of printing. Ford Motor Company reserves the right to supercede this information with updates. The most recent information is available through Ford Motor Company’s on-line technical resources.
Copyright © 2004 Ford Motor Company