Fulltext TSBs

Technical Service Bulletins

TSB
13-10-2
  • 6.7L DIESEL – STOP SAFELY NOW INSTRUMENT MESSAGE – MALFUNCTION INDICATOR LAMP (MIL) ON WITH DIAGNOSTIC TROUBLE CODES (DTC) P200E AND P200C
Publication Date: October 4, 2013

FORD:
2011-2012 F-Super Duty

This article supersedes TSB 12-7-1 to update the Issue Statement and Service Procedure.

ISSUE:

Some 2011-2012 F-Super Duty vehicles equipped with a 6.7L diesel engine may exhibit a Stop Safely Now instrument cluster message with the MIL on with DTCs P200E and P200C.

ACTION:

Follow the Service Procedure steps to correct the condition.

SERVICE PROCEDURE

  1. Using the Integrated Diagnostic System (IDS) or equivalent scan tool, retrieve all continuous memory DTCs. Are DTCs P200E and P200C present?
    1. No – this article does not apply. Refer to the Powertrain Control/Emissions Diagnosis (PC/ED) manual for normal diagnosis.
    2. Yes – proceed to Step 2.
  2. Obtain the exhaust gas temperature (EGT) readings from freeze frame data when DTCs P200E or P200C were set. (Figure 1)
    1. If only one EGT sensor is reading 850 °C (1562 °F) or higher, replace that sensor. Refer to Workshop Manual, Section 303-14B.
    2. If two or more EGT sensors are reading 850 °C (1562 °F) or higher, this article does not apply. Refer to PC/ED manual pinpoint test RC to diagnose the concern. EGT locations are different for chassis cab (narrow frame and pickup truck (wide frame). (Figure 2)

PART NUMBERPART NAME
AC3Z-5J213-BEGT Sensor

WARRANTY STATUS:

Eligible Under Provisions Of New Vehicle Limited Warranty Coverage And Emissions Warranty Coverage
IMPORTANT: Warranty/ESP coverage limits/policies/prior approvals are not altered by a TSB. Warranty/ESP coverage limits are determined by the identified causal part and verified using the OASIS part coverage tool.

OPERATIONDESCRIPTIONTIME
131002A2011-2012 F-Super Duty 6.7L: Diagnose, And Replace One (1) EGT Sensor (Do Not Use With Any Other Labor Operations)0.5 Hr.

DEALER CODING

BASIC PART NO.CONDITION CODE
5J21342



Figure 1 – Article 13-10-2




Figure 2 – Article 13-10-2


NOTE: The information in Technical Service Bulletins is intended for use by trained, professional technicians with the knowledge, tools, and equipment to do the job properly and safely. It informs these technicians of conditions that may occur on some vehicles, or provides information that could assist in proper vehicle service. The procedures should not be performed by "do-it-yourselfers". Do not assume that a condition described affects your car or truck. Contact a Ford or Lincoln dealership to determine whether the Bulletin applies to your vehicle. Warranty Policy and Extended Service Plan documentation determine Warranty and/or Extended Service Plan coverage unless stated otherwise in the TSB article. The information in this Technical Service Bulletin (TSB) was current at the time of printing. Ford Motor Company reserves the right to supercede this information with updates. The most recent information is available through Ford Motor Company's on-line technical resources.