Technical Service Bulletins
|Publication Date: December 12, 2008|
|2008-2009 E-Series, F-Super Duty, Low Cab Forward|
Some 2008-2009 F-Super Duty, Econoline, and LCF vehicles built between 5/18/2007 – 11/1/2008 and operated in cold climates typical to -35 Â°F (-37 Â°C) and below that are equipped with a 5R110W transmission, part numbers starting with 8C3P-7000, 8C2P-7000, 8E7P-7000, 9C3P-7000, 9C2P-7000, and 9E9P-7000 built without the factory installed external in-line transmission filter can experience premature Low/Reverse One way Clutch failure related to lack of lube while operating in -35 Â°F (-37 Â°C) and below temperatures.
Follow the Service Procedure steps to correct the condition.
Verify the vehicle build date for F-Super Duty or E-Series vehicles built between (5/18/2007 – 10/27/2008), or LCF built between (5/20/2007 – 11/1/2008). Verify vehicle is built without factory installed external in-line transmission filter. Verify transmission -7000- part number prefix starts with (8C3P, 8C2P, 8E7P, 9C3P,9C2P, and 9E9P). If all of the above apply, refer to the following:
- Overhaul the transmission following the Workshop Manual, Section 307-01.
- While performing a transmission overhaul, replace the front pump with a 9C3Z-7A103-B pump assembly. This new replacement pump assembly can be identified by the engineering part number (9C3P-7A103-AC) visibly etched on the machined front face adjacent to bolt hole.
NOTE: DO NOT INSTALL THE 9C3Z-7A103-B PUMP INTO A VEHICLE THAT IS EQUIPPED WITH A FACTORY INSTALLED EXTERNAL IN-LINE TRANSMISSION FILTER.
|PART NUMBER||PART NAME|
Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
|MT082604||Use SLTS Operations If Available; Claim Additional Diagnosis Or Labor Performed As Actual Time||Actual Time|
|BASIC PART NO.||CONDITION CODE|