Technical Service Bulletins
|Publication Date: JUNE 1, 2001|
Water and dirt can migrate into the tail lamp lens through the lens vent hole on some F-150 Flareside and Super Crew models only. Dirt, mist or fog can accumulate in the lens as a result of this moisture.
Install foam sealing block onto the lens vent. The foam block will stop any further moisture from accumulating in the lens. Refer to the following Service Procedure for details.
- Remove the tail lamp assembly.
- Clean the backside of the tail lamp and body panel to remove any debris or moisture.
- Insert the Foam Sealing Block (1L3Z-15278C90-AA) into the hole where the tail lamp wire harness is routed through the body panel.
- Reinstall the same tail lamp.
NOTE: DO NOT REPLACE THE TAIL LAMP UNLESS IT IS BROKEN. THE TAIL LAMP LENS WILL CLEAR UP ON ITS OWN OF ANY INTERNAL MOISTURE.
|PART NUMBER||PART NAME|
|1L3Z-15278C90-AA||Foam Sealing Block|
OTHER APPLICABLE ARTICLES:
Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage
|011112AB||Install Foam Sealing Block (Includes Time To Remove And Install Tail Lamp Assembly) – Both Tail Lamps||0.3 Hr.|
|011112A||Install Foam Sealing Block (Includes Time To Remove And Install Tail Lamp Assembly) – One Tail Lamp||0.2 Hr.|
|BASIC PART NO.||CONDITION CODE|
108000, 110000, 111000, 201000, 201200
Copyright Â© 2001 Ford Motor Company