This build has taken 3 years so far and has been upgraded from my original plan
You can see I originally had the crown Vic front suspension but it was a little too wide for the truck so I switched to a mustang 2 ifs setup it has a 5.3 turbo ls motor should be around 650 wheel horse I also put an 8.8 rear axle with triangulated 4 link

 

Nice first post. Can't believe there's no pics of the motor!

 

This is the crown Vic suspension

 

Im trying but I can't figure how to do more than one pic at a time??

 

This is what it looked like with the crown Vic suspension and +32 wheels it would rub if you turned just a little

 

Here it is with the mustang 2 suspension it turns nice and sharp without rubbing

 

Here is the first version of the motor and turbo setup

 

And here are the rest of the pics

 

very nice,a lot easier now days,when I did my 60 back in 82 I cut the frame and subframe it with a ltd front frame gave me disc brakes,coils and power steering,cross brace was for 460 so I went with a 460 with 429 heads and a crazy comp cam 292,389 gears in 9in,high 11s in the quarter mile,like how your truck sets low,keep the pictures coming,

 

Here are the rest of the pics I have for now I ordered I piece door glass that's tinted along with the back glass that's tinted




Here are some rear axle and 4link pics



I had a custom gauge bezel made


The seats are out of a dodge Dakota and a lokar shifter









Gas tank is a tanks inc. baffled mustang tank

 

nice,should run like rape ape with that motor,

 

A little more done last night wastegate mounted trying to decide if I should plumb it into the exhaust or just have a screamer pipe ????

 

Looks like the second turbo turned out much cleaner than the first attempt. Are you leaving the patina or painting it?

 

I am gonna finish the engine bay like a show truck but leave the outside patina. End of this month the headers, y pipe, and up pipe are going to be ceramic coated and I will wrap the down pipe should look really nice

 

How did you make the one piece door glass work in regards to the regulator, glass channels and weatherstripping? Do they make a conversion kit? Thanks, Jim