Originally Posted by
fordno1
Alloro, watch what you say.
No I will not watch what I say. I don't care how good of a welder you or an instructor from the local college are, you do not have the equipment to test this type of fabrication to prove it's road worthiness. These arms are responsible for holding the entire rear axle and suspension in place. You have no idea how the materials used are going to hold up to the constant beating, stresses, heat, cold, or road minerals over time.
As to the PMT ones, I have no knowledge as to whom welds their products. But I do know their product has been and is being used without any issues.
Cutting cost corners and putting people lives on the line is what you're trying to tell me is okay here. Do you really think that's a point you can push while calling it being responsible?