<table style="background-color: rgb(218, 222, 235); text-align: left; width: 810px;" cellpadding="5" cellspacing="0" border="1"><tbody><tr><td style="vertical-align: top;">
Provided by
Bern_F150_4x4
<table style="background-color: rgb(244, 244, 254); text-align: left; width: 800px;" cellpadding="5" cellspacing="0" border="1"><tbody><tr><td style="vertical-align: top;">
Just finished, 1986 F250 TTB frame bushing replacement - Ford Truck Enthusiasts Forums
Originally Posted by
Bern_F150_4x4
Here's a couple pics of the installer tool I made. There isn't a lot of room to do this job so a small press is required to work around the frame/brackets/suspension. Like I said, I dragged my feet on making this thing so no AutoCad drawings, no measurements, hell it's not even square! Strictly an eyeball job; cut, drill, weld and tap. Well I did deburr it...
</td></tr></tbody></table>
</td></tr></tbody></table>
<table style="background-color: rgb(218, 222, 235); text-align: left; width: 810px;" cellpadding="5" cellspacing="0" border="1"><tbody><tr><td style="vertical-align: top;">
Provided by
86_bigred
<table style="background-color: rgb(244, 244, 254); text-align: left; width: 800px;" cellpadding="5" cellspacing="0" border="1"><tbody><tr><td style="vertical-align: top;">
ttb u-joint replacement - Ford Truck Enthusiasts Forums
Originally Posted by
86bigred
here are some pics of the passenger side ttb u joint replacement.
here's the wheel removed
this is the locking hub removed
</td></tr></tbody></table>
</td></tr></tbody></table>
<table style="background-color: rgb(218, 222, 235); text-align: left; width: 810px;" cellpadding="5" cellspacing="0" border="1"><tbody><tr><td style="vertical-align: top;">
Provided by
dohc_chump
<table style="background-color: rgb(244, 244, 254); text-align: left; width: 800px;" cellpadding="5" cellspacing="0" border="1"><tbody><tr><td style="vertical-align: top;">
The TTB Thread - Ford Truck Enthusiasts Forums
Originally Posted by
dohc_chump
</td></tr></tbody></table>
</td></tr></tbody></table>
<table style="background-color: rgb(218, 222, 235); text-align: left; width: 810px;" cellpadding="5" cellspacing="0" border="1"><tbody><tr><td style="vertical-align: top;">
Provided by
Encho
<table style="background-color: rgb(244, 244, 254); text-align: left; width: 800px;" cellpadding="5" cellspacing="0" border="1"><tbody><tr><td style="vertical-align: top;">
Ford (87 - 96 F-150/Bronco) front end rebuild
Originally Posted by
Encho
Before you start reading, i want to state just what is contained and what isn't in this write-up:
What was done?:
- Automatic hubs where replaced with Warn manual hubs
- Bearings and seals in the hubs
- Brake rotor and pads
- Inspection of the front axle u-joints
What wasn't?:
-Replacement of the bushings, ball-joints, drag link or anything else related to the steering.
Of course, all of this was done to the Dana 44 TTB that's installed in my 1993 Bronco.
Ok, lets get started:
</td></tr></tbody></table>
</td></tr></tbody></table>
<!--
End close of outermost table
-->