Originally Posted by
Daddyo's garage
I crawled under the truck tonight and took some measurements. From the rear yoke where the u-joint fits, to the tip of the trans output shaft is 51". The output shaft measures about 1 1/4", with 28 splines. Anything close? I may have found one in my neck o' the woods. Will let you know.
Thanks!
Hey Mike, I am at work now but will check in the morning. I have a 28 spline slip yoke that came on the drive shaft I pulled from an explorer. I needed a 31 spline to fit the C6 I installed. It uses the 1330 universal joint. Not sure of the diameter. If it will work you can have it. I'll shoot you a PM tomorrow after I check the diameter and get your shipping info. EDIT: Should have finished reading the rest of the post! Glad you found one.