Test results did show that wire did not have any volts. I have get the tan/white wire traced to where it will deliver 12 volts. About the headlight switch plug,, 3 pins have 12 volts and 6 which include the Tan/white have none. I am trying to get a "Good" wire diagram. The wires go into the harness and disappear, lt looks like I may have to get the Inst. Cluster out of the way. The Chilton book IMO is not much help with finding out where the tan/white wire goes to and from. So I have to get 12 volts out of the tan/white wire. All help is appreciated & welcome. Thanks Dave you were on the ball with this.