Does anyone have pictures where the CKP sensor is located. i have take it apart on the pasenger side through the wheel well but i cant find the sensor where the haines manual says its at. Any help

I need some help with my 6.0 2004 f250 Power Stroke. It started acting up upon start. It finally started and ran rough until it warmed up. It shows the check engine light so i took it to get tested and came back with the following codes:
p2617 crankshaft position out
p2614 camshaft position out
p0261 cylinder 1 injector low
p0264 cylinder 2 injector low
p0267 cylinder 3 injector low
p0270 cylinder 4 injector low
p0273 cylinder 5 injector low
p0276 cylinder 6 injector low
p0279 cylinder 7 injector low
p0282 cylinder 8 injector low

then i left it alone for about a week and did not run it i went back to it and now it does not start. it turns over but no start.
I replaced the following:
both of the fuel filters. no luck
The camshaft positioner sensor no luck
I am about to replace the CKP sensor but i can not find it i read on the HANES manual for this truck but it has very limmited info. I have read online but i still cant determine the location and how it looks like. Some say it is behind the air compresor but i am having difficulties removing the compressor. Any help or any pictures would be appreciated. Thank you in advance.
Leo
<!-- / message -->