Removal and Installation

All vehicles

1. Remove the liftgate trim panel.

o Position the water shield aside.

Expedition

2. Remove the 4 nuts and the license lamp housing.

o Disconnect the electrical connector.

3. Squeeze release tabs and remove the video camera and bracket from the license lamp housing.

Navigator

4. Remove the liftgate parking lamps.
5. Remove the 6 nuts and the license plate housing.

o Disconnect the electrical connector.

6. Remove the 2 screws and the video camera bracket.

All vehicles

7. To install, reverse the removal procedure.

Doesn't look like there is a part number on the sheet. I would go into a parts department with this and ask if it's been added.