Thread: 1963 Ford C700. What size engine?
View Single Post
  #2  
Old 10-01-2009, 10:43 AM
dusty64f100's Avatar
dusty64f100
dusty64f100 is offline
Junior User
Join Date: Mar 2004
Location: valliant
Posts: 92
Likes: 0
Received 0 Likes on 0 Posts
Try this page
TECHNICAL
A Y block should have a distributor in the back and an air gap manifold
I would suggest you measure the bore and stroke after you pull the heads off and that'll tell you exactly the cu in.

Are you sure a 330 isn't an FE, such as the 361/391 industrial engines?
 
Reply Like