Originally Posted by
kstones63
I am not familiar with the EBPV plunger. What is it and where is it? It has been 10 years since I had that apart.
Kevin
Check out Mike's picture below. See the rod/stem sticking out from the left side of the pedestal? The assembly is held in by a snap ring.
It's my understanding that the O-rings are usually the cause of pedestal oil leaks, but in my case the O-rings were fine (just replaced) and it was my EBPV plunger that wasn't sealing against the cylinder walls properly.
Originally Posted by
big poppa pump
With your engine running, you can see with a flashlight if the oil is coming from that spot.
Stewart