No, I haven't bought it yet. I wanted to consult the panel first. I like to do my research.

It is going into my 1974 F100 w/ a 302 w/ a manual trans (3.03 ford). I've been so concentrated on tearing down for resto, I haven't gotten my engine's checkup yet, but I will rebuild as needed. After I do, I'm going for a nice crane cam and some headers to go with this new (used) carb. I also found out this 2150 I'm looking at has a 1.21 venturi, which I've also added that into the calculations. According to Crane's cam calculator, I'll be producing exactly what I want, a little over 200 HP, around 300 TQ, nothing killer, but not much expense for 80-100 HP and 70 ftlb TQ. My carb being 1.08 means it should sell nicely to the Jeep guys who want an upgrade. Everybody wins!

Thanks for your help Jermafenser!