Originally Posted by
Az.scarecrow
I'll load the processor back up and see how hot she gets, I'm just not to sure if I could get the moisture out thru the 3/4" vent tube.
It should steam like a tea pot. I put a 4" fill/vent hole on the top of my processor. I watch the oil to see the water bubbling up in the sight gauge and the steam will just pour out.
I will heat is as long as needed until there is no more steam (that's the water). I can usually completely dewater the oil in a little over 2 hours.
It might take you longer with a 3/4" vent and your heat source.
good luck