But then you run the power to the lights down the long runs to the bulbs..?
Did you increase the wire size too?

I was thinking of moving the relays under the front gravel gaurd, short haul for the +12V to the bulbs. Battery is in the engine compartment for me.

the main harness wires will be coming thru the chassis at the gravel guard
(no wires showing in the engine compartment other than the two battery leads and this one hot wire to the relays..)

I need one feed for the dual fans, and one feed for the lights. figured I could hang them on the gravel guard cross support (bottom to top of gravel guard)..

sam