Originally Posted by mongo75
Jason uses a Donaldson filter with a wrap-around heat blanket to filter and preheat the oil. It's your responsibility to run "clean' oil in regards to any water content. You can always run a Vormax filter like I have on my truck for themain fuel- it swirls the fuel to drop any water or junk in it. I can't answer from experience the other questions, but I would say if you can rebuild an engine, then you can install this in about a good whole day.
I'm not trying to dodge the responsibility of getting the oil clean of the water and food pieces...just looking for some advice from the manufacter of a kit I'm serouisly looking at; if I could just only get the department of finanice & adminstration to turn loose of the money. Has anyone tried their new filter/pump Aluminum billet block? From what I've seen and read of it looks interesting.