I am a complete Flathead newbie, so...
this is where I present my self as a proud owner of a flathead...finally. First thing I'd like to do is see if the engine will rotate. Which direction should I spin the crank? The PO says he filled the whole engine up with oil 14 years ago. It is an 8BA. I want to keep the engine original looking, yet run it 12v neg. ground. Is there an alternator that looks identical to the generator? would my local NAPA carry a rebuild gasket set? Is there any books out there that are good for rebuilding these things? Does the Pertronix ignitor work well on these?
Last edited by havi; 01-07-2008 at 09:44 PM.