Originally Posted by councillor
It looks like it's a matter of removing the 3 outside bolts but there's a few rod's and stuff connected there also. !!!
Do you happen to have a schematic on that?
Is this what you're asking for? If not, let me know and I'll check for some different ones.
- Disconnect the actuating rods.
- If equipped disconnect the actuating rod from the lock cylinder.
- Release the locking clip.
- Disconnect the exterior door handle actuating rod from the front door latch.
- Remove the screws and position the front door latch aside.
- Disconnect the electrical connectors.
Hope that helped.
Stewart