Hey guys, been a while since my last post. I appreciate all the help you all give. I've been dealing with a crumbling instrument cluster housing, and a bad printed circuit. Since the cost is comparible I've decided to go aftermarket with all of my gauges. The only problem is that every wiring diagram I've found for this truck show 13 pins on the connector to the instrument cluster. My truck has 14 pins. Some of the pins have two wires going into the connector as well. So far I've been able to determine the water temperature, oil pressure, fuel level, and a few others by simply looking at diagrams for wire color and testing for continuity between connector and sender. The only problem is that I can't figure out what some of these wires are for, and as I said the diagrams don't have the same connector I do. If anybody knows where I can find a different diagram that might help I would greatly appreciate it. Thanks