I bought the book today and have found the table you are refering to along with everything else. Its on page 1- 49 at the bottom. It says to adjust the valves on number five when number one intake is JUST STARTING to open. That would NOT put number one at TDC AND FIRING because thats at the very end of the exaust stroke for number one. Number five would have fired.
I put the dial gauge on the number one intake and moved it five one thousanths into its cycle. If thats the case then five ( the sister cylinder... for lack of a better description) should be on TDC? getting ready to fire again? if thats the case I could do both valves at once, I am sure.
If not... then I would have to do each valve seperately for the "intake" ( where the book says to start) and then " follow the same procedure for the exaust" ???? to quote exactly..rotate around to get the exaust? The book is confusing me.