got some new bearings to install
well as I was saying at the meeting I had this growl when I get 65+ on the highway and it turns out my inner wheel bearing is shot on the driver's side. I had replaced my lockout hub on sunday that was on the passenger's side so today after work I was going to do the other side but when I pulled off the hub I found a lot of metal shavings in there. So I have everything off and bought new bearings, rotors, and pads but I cannot get the spindle to seperate from the knuckle. I have removed the 5 bolts then heated it, used kroil, smacked it with a huge plastic mallet and it will not come off for anything. In the haynes book it says that it's two pieces and it does look like it is but geez....