Are you using the EGR valve? What exactly do you need?. Here are the basics.

1) The Big port on the Holley, either on the pass. side rear or on the back of the carb(Depends on which Holley you have)
2) The tranny modulator valve and Power brake booster and HVAC controls(if you have A/C) go to the threaded in ports on the back of the intake. (Use the one out of the stock intake)
3) The distributor vacuum advance goes to the port on the pass side of the carb, just in front of the choke.
4) Put a cap over the one on the bottom front of the carb down by the intake.

5) The choke should be wired to the Stator wire of the alt. The easiest way to find it is to follow the wire off of the voltage regulator that goes to the S terminal. Splice into it and run your choke wire to there.

6) MAKE SURE THAT YOU INSTALL A GOOD INLINE FUEL FILTER!!! Holley's do not take kindly to any dirt getting into them. They will flood and give you all kinds of problems if they get dirt in them.
Jimmy