ABS Brake Problem
I'm not sure about the '95, but on my '99 there are three sensors. One on each front wheel, and one on top of the differential. The two fronts are held in place by a single 8mm bolt. Remove the bolt, and the sensor will pull straight out. It has a long cylinder (about 1-1/2 inches long), and a second shorter cylinder that the bolt goes through. Wiggle the sensor while pulling straight out. The wire is about 2 feet long, and connects near the bumper...disconnect by pulling straight down and squeezing the holder clip.
The rear sensor mounts on top of the differential with a 10mm bolt. It comes out at a forward angle. There is an o-ring on it, so it takes a little more wiggle to get out. The wire connects right at the sensor.
Front sensors: $24.95 each at dealership
Rear sensor: $10.99 at dealership
Like I said, I don't know if the '95s use the same sensors or mounts...hope this helps.
Don.