i am in the twin cities in st paul.. i could ship em though, probaly wouldnt be too much if its in state. if i get motivated enough, i might take the dremel to the small humps in the exhaust ports so they are good to go. they do have the bolt holes drilled/setup for the 351w, you would have to use the bushings for the 7/16 bolts on a 302/289. .. but i had em running, and they were sandblasted and fresh looking when i got them. now they are blue and could use a wash from sitting on the shelf in the shed. the part number i think is c8ae or c8oe on them.