View Single Post
  #5  
Old 08-15-2014, 05:44 PM
Gaugepro's Avatar
Gaugepro Gaugepro is offline
Senior User
 
Join Date: Aug 2014
Posts: 191
Gaugepro has a good reputation on FTE.Gaugepro has a good reputation on FTE.Gaugepro has a good reputation on FTE.
IDM... Gets hot and acts up.

Just a guess at this point. Also check all your wire harness connections. If there getting heat the plastic can swell and might make a normally good connection bad. UVC, UVC gasket. Even injector harnesses.

Do you use Dielectric grease on everything?
Reply With Quote