Ford Truck Enthusiasts Forums - View Single Post - has anyone welded the seam
View Single Post
  #29  
Old 06-07-2014, 05:11 PM
AXracer's Avatar
AXracer AXracer is offline
Post Fiend
 
Join Date: Oct 2004
Location: Durham NC
Posts: 15,753
AXracer has much to be proud ofAXracer has much to be proud ofAXracer has much to be proud ofAXracer has much to be proud ofAXracer has much to be proud ofAXracer has much to be proud ofAXracer has much to be proud ofAXracer has much to be proud of
The 0.023 is only available in 11# (8") spools now. The 0.030 is still available in 2# spools while supplies last. If your welder only handles the small spools, I'd order ample supply of the 0.030 IMMEDIATELY. Even the heavier wire in Easy Grind is better than any other wire for sheetmetal and general purpose, so stock up while you can.
Reply With Quote