Thread: 6.4 Air in fuel
View Single Post
  #24  
Old 04-25-2014, 08:31 AM
vloney vloney is offline
Postmaster
 
Join Date: Feb 2006
Location: waynesville, mo.
Posts: 3,067
vloney has much to be proud ofvloney has much to be proud ofvloney has much to be proud ofvloney has much to be proud ofvloney has much to be proud ofvloney has much to be proud ofvloney has much to be proud ofvloney has much to be proud ofvloney has much to be proud ofvloney has much to be proud of
Quote:
Originally Posted by Mudslinger72315 View Post
No, it isn't running yet. Trust me, I am ready too. It's going to feel like a new truck when I get it going. I am home now and I cleared and ran the codes again. They are as follows: (new ones showed up)
P-1000 Mass/volume air flow circ range/perf
P-179a
p-0488 EGR throttle pos ctrl (I know why this one is here)
p-0091 Fuel press regulator ctr circ low
p- 0003 Fuel Volume Regulator ctrl circ low
p - 0670 glow plug ctrl circ error
p- 0684 glow plug ctrl mod to pcm circ range/perf
and p-1000 monitor checks not complete.

Should it still start? I am not laying on the starter any longer than 20 seconds or so.
Also, I remember reading a post that someone had some kind of a no start issue and it ended up being his passenger side battery. My passenger side battery is bad (I have it disconnected and a battery charger/starter connected to it. Could that be my entire problem?

I will PM you my cell number. I can pull and install the turbos with my eyes closed now. I just need to learn diagnostics.
Hate to tell you this, but you might be in for some major work. Fuse 72 blowing and P0091 and P0003 tells me that theres something wrong with the circuitry to your high pressure pump usually the gasket with the pass through wiring.
__________________
ase master tech--fmc senior master tech 92 4x4 ranger 4.0
Reply With Quote