Well after a few days of knuckle busting and painting, I have installed the Pertronics and the flame thrower coil. Replaced all hoses,fluids and clamps. New distrib cap rotor and wires. Widened the gap on the spark plugs no need to replace because they appeared to be new. The hardest part of the job was grinding the rivets off the brackets to replace the radius arm bushings. After I replaced those worn out bushings should I have the front end realign? The wires under the dash must have been changed before I got it because since I replaced the points with the Pertronics module and new coil it starts with a flick of the key. Sounds and runs strong. Absolutely no smoke white or blue or anything. I got a chance to use a inspection camera(Fiberoptic)when I pulled the plugs and the pistons and cylinder walls were pristine. No pics because I can't figure out how to post them.