We'll I had to take a few days off and do some other stuff but the blast cabinet works a lot better with the vac and dust trap set up, peices are all cleaned up. I did some fabrication on the rear cab crossmember, three areas on it were rotted.
I also sand blasted this crossmember again after fab but didn't take any pics, probably should have.
Cross members and shock towers are now painted and awaiting installation. I figure a few days and the paint should be hard enough to assemble.
Ended up ordering some better paint guns. They should be here in 3-4 days and the top coating can begin.
Next step transmission and transfer case!