I have a question. I have a 1999 ford e250. the info tag says i have a E4OD trany. I am rebuilding the trany and have taken it apart. some of the parts resemble the E4OD like the output shafe on mines which dont carry a speed sensor reluctor wheel and i dont have a turbine shaft sensor. also my planetary carrier has 3 pinion in it. my casing has a lube orifice plug but my intermediate servo assembly just pull out instead of haveing a ring to hold it in as per the E4Od manual. Is there a way to be 100% certain whitch trany i have E4Od or 4r100? after pulling it apart, i found the thrust bearing on the output shaft distroyed. All the clutches still have the id numbers writen on them. they are however slighty discolored, can i just reuse them and replace my seals?