Picked up this van that the PO had gutted. I was going to put in some dome lights. Haynes manual useless, so ordered a Chilton's. In the meantime, thought I'd just toddle out there with my meter and fiddle. Found that there was 12v at driver's door with door open. So far, so good. Then I did a stupid thing: I was using an old tail light bulb in a socket as a "test light". Put it across the battery terminals to verify that it was working and "POP!". I think it was so old and crusty it just shorted. Blew the 30 amp fuse in the fuse box. I replaced the fuse. Now, no 12v to fuse box when connected to (driver's side) battery. I checked the only fusible link I could find, which was right above battery. I think I frapped something that feeds the fuse box. I have ordered an electrical manual off ebay. Also checked the motorcraft site, but they only go back to 96. If any kind soul has access to the fuse box wiring, or a diagram showing how it is fed, I would be grateful. Thanks,
Steve
P.S. Forgot to mention: I am the "oddball", as this is a 6.9L diesel.