Fished the pushrods out lastnigt, they were both slightly bent. The lifters looked fine, the two valves were stuck on them cylinders. I cleaned everything good and oiled them up while working all of them with a rubber mallet. They seem to all function fine now. I haven’t started it yet so we will see. I want to change the oil and filter this weekend along with a few other things first. I think everything just needs to be lubed good and worked over from sitting. There doesn’t appear to be any damage. The bent pushrod is very slight, almost not even noticeable. I suspect I did that when I started the engine when I first brought it home and the valves being stuck.