F800 Brake/Turn Signal Wiring
Greetings all,
Long time reader, new member, hoping to be able to get help and help others. I have a 1998 F800 with a cummins 5.9. I lost my turn signals, and am trying to get them back. Under the dash, there was a red wire spliced into a fuse, spliced into a blue wire that goes to the brake pedal button. The fuse was melted, so I removed it, and straight wired the red and blue wires. I have brake lights, but no turn signals, however I do have hazards.
However, if I turn on the hazards, the electric brake motor comes on at each "flash."
Should I put the fuse in, or should something else go in? so It does not activate the brake motor. Or is there some other thing I should look for? Any idea would be greatly appreciated.
Thank you,
John