Originally Posted by
_red rocket_
So, if I get this straight...
New 10 gauge fused wiring from the battery for an always hot power
New 10 gauge ground, short length
New 10 gauge from fuse block #44 (part of the upfitter switches)
Or are you guys using fuse #44 for both the AMP's remote and always hot connection?
I am finally going to get this done this weekend
thx
If 10 awg is the recommended gauge for your amp, then you only need that for the power/ground.
The amp's remote turn on can be smaller gauge. use #44 for amp turn on only! Also make sure that the fuse for your 12v constant is up near the battery.