Originally Posted by
theodore/teddy
Blaine; I just went out and checked my w/strip The ends meet just below the style line on the back side of the door about where the latch mechanism is (sorry for the misinformation earlier). When I was putting them in I thought there was definitely a right and left seal. I did have to let them settle in with the door closed as far as it would go for a day or two, before final adjustment of the latch/striker plate.
Good luck in your quest.
That's ok. After my last post I looked at them again and was kind of thinking with the bends in the one very end of the seal matched up better being on the back side of door. And that is about where the two ends would end up if that thick part is under window. Atleast the two ends meet up on the back side of the door. Because being on the front side it is almost impossible to reach in there as it is without fighting two ends of the seal.
Tomorrow I am planning on tackling this task and getting them both glued in. Hopefully I will have something to update with tomorrow.
Thanks Again Everyone!!
We'll see if I get anywhere tomorrow.