Just changed the multifunction switch to address a buzz I was getting when I engaged the right turn signal.

Not sure I needed to do so but I disconnected the batteries. I was worried about setting off the air bag.

Generally straightforward but I had some trouble with a connector on the ignition cylinder that seems to be what triggers a beeping sound when you leave your key in the ignition after shutting off the car. I hope it doesn't give me problems down the road.

I also sprayed the wheel wells on the inside of my bed with spray on DupliColor bed liner. If the wheel wells turn out OK, I'll use the 1 gallon kit to coat the floor of the bed after I finish applying the Eastwood Rust Converter product I purchased.

Have a nice Labor Day.