Originally Posted by
Broncomomma
I have an 89 Bronco with 500,627 miles on it that the timing gears went out, I have managed to get the main gear back on but the smaller one is a bit of a problem, there is barely 1/4 of a inch left until it is on the rest of the way and I am having a hard time completing this last bit so I can put the truck back together. Any suggestions would be greatly appreciated.
Also there are no spacers involved in this set up as the engine is a Straight 6 300....4.9L...no chain or belt or spacers,,also the gears that are replacing the old ones are factory.