Thank yall for the replies so far.

tdappleman- the light is blinking not solid.

njneer1- The theft light blinks at a steady rate but not rapidly. When the key is in the on position only the battery light illuminates and no others. None of the gauges move either. The wait to start light doesn't come on or any others. And in this state the engine will turn over just not start.

I disconnected both batteries last night and charged one. I just swapped the charger to the other battery and will give it another try when it is full. I hope your right though, one of the batteries took a dive and caused this condition. I am baffled as to why it will turn over though and no gauge activity or start.

I will post results after batteries are charged up again and go through these next steps.

Any ideas why AE would not make a connection to even try and get in and program keys or look at codes anymore?