I searched this site, Google and YouTube for a DYI on how to replace the blend door actuator in my new-to-me 08 SD EX Cab. All I come up with is Explorer, Taurus, 150s etc...Nothing on a newer 250.
Dealer had the actuator for $35. Its 20* outside and it won’t fit in my garage w/o leaving the door open. So I’d like to do this as quickly as possible with the salamander goin full blast.
Has anyone performed this repair? I’d like an exploded view of the dash area or a YouTube DYI would be great.
Any tips? Such as where the temp control **** should be positioned before installation? I do know the key should be off so there isn’t voltage to the actuator so the learning position won’t be outta wack, but that’s the only bit of info I could find.
TX! Steve