Wanting to Duplicate 1st Gen Lightning Factory Exhaust
Hello, all. First post here on the forum.
Have a '94 F150 regular cab, short bed. Cats were gutted and I had a "muffler shop special" glasspack welded on a couple of years back.
I'm really wanting to duplicate the 1st Gen Lighting exhaust setup. I have done some research on the net, but cannot find any detailed information, and I do not know anyone personally who owns a 1st Gen.
I basically just need to know what aftermarket tips are as "close" as you can get to the OE tips? I prefer polished stainless steel; just need to know length, outlet diameter, rolled cut-ends or not, and 45* or 15* degree slants... Also, some measurements as to where to have the tips welded would be great as well.
Thanks in advance!