A text paste from the shop manual from a 2007 - hope it helps!
Removal
NOTE: Programmable module installation (PMI) only needs to be carried out if the DVD player is being replaced.
- Upload the DVD player configuration to the scan tool. For additional information, refer to Section 418-01.
- NOTE: Open the DVD player display.
Remove the 4 screws.
- Remove the DVD player.
- Pull down on the sides of the DVD player to disengage the clips from the bracket.
- Using a suitable tool, push the rear most U-hook forward and release the U-hooks.
- Hang the DVD player on the J-hooks and disconnect the electrical connector.
- Remove the DVD player from the J-hooks.
Installation
- Hang the DVD player on the J-hooks.
- Connect the electrical connector.
- Remove the DVD player from the J-hooks.
- NOTE: Tilt the DVD player, as necessary, to align it correctly.
Align the left side guide pin with the left side locating hole.
- Lift up the right side of the DVD player and engage the U-hooks.
- Install the 4 screws.
- Push on the left and right sides of the DVD player to engage the clips.
- Download the DVD player configuration from the scan tool. For additional information, refer to Section 418-01.