Originally Posted by
1L243
I got the new lights in and they look great. One trick that I got off this site was sliding a 13mm socket over the **** with the two wings. The problem now is on my old lights a torx driver would adjust the lights now the adjuster looks like a torx driver, so I guess I need some kind of a very small socket or special tool? But, they look great.
Doug
The 13mm sockets did not work for me, but a 14mm open end wrench did. Put the wrench on where the wings aren't and rotate the wrench 90 deg upwards while gently pulling on the headlight. I just got my new clear lights installed. About an hour for the 1st one and 10 mins for the 2nd one.