Thread: '99 Ranger - Parts for Hub & Wheel Bearing Replacement
View Single Post
  #5  
Old 03-24-2011, 10:10 AM
Rockledge's Avatar
Rockledge
Rockledge is offline
Post Fiend
Join Date: Jan 2003
Location: Connecticut
Posts: 9,748
Likes: 0
Received 12 Likes on 12 Posts
Originally Posted by MN_FarmBoy
Thank you for the responses, guys.

I am going to put the truck on a jack this weekend and check the amount of play myself. What would be a safe (not fix it) tolerance?

Also, if I do go ahead and do the fix, does anyone have responses to my questions in the first post?

Thanks again!
You might find THIS article helpful.

Not sure about the tolerance, but like I mentioned, if your 4x4 is engaging/disengaging OK and you aren't hearing any noises out at the wheel ends, then the factory bearings are most likely fine.
 
Reply Like