Originally Posted by
lhud
NITRO,
Take one of your ball joints (lower is largest) and see which pickle fork fits that one.
I purchased some time back the IR impact: 1/2" drive with 1000 ft-lbs torque; Mdl IR2135QTIMAX.
It is light weight and a strong tool.
The Advance Auto kit (large one) will have all the required sleeves.
Not a bad job, but a little time consuming and some grunt work.
Very satisfying considering the money you will be saving.
Good call on the IR. I found a 244a used on ebay for $45, should be a great impact gun.
I'm just hoping I dont have to pay someone to do this. I only have a week timeframe to do this on a busy schedule between when I get the parts & when I'm leaving for a 3000 mile road trip...